Standard Life 250 Series
One Flute Compression Solid Carbide Router Bits
Compression spiral, a combination of a down-cut flute and up-cut flute to maximize edge quality from the top and bottom of material.
Use on double side laminates (melamine, HPL, vinyl, painted board), veneers, solid lumber and plywood.
Feed Rate: Wood Composites - 600 / Hardwood - 400 / Softwood - 450
*Based on 1/2” Diameter Tool, Cutting 3/4” Stock at 18,000 RPM
Information above should be used as a guideline – results may vary
All figures are shown as IPM (inches per minute)
Note: For smaller diameters than reference–Reduce feed rate.For Larger diameters – Increase feed rate
Use on double side laminates (melamine, HPL, vinyl, painted board), veneers, solid lumber and plywood.
Feed Rate: Wood Composites - 600 / Hardwood - 400 / Softwood - 450
*Based on 1/2” Diameter Tool, Cutting 3/4” Stock at 18,000 RPM
Information above should be used as a guideline – results may vary
All figures are shown as IPM (inches per minute)
Note: For smaller diameters than reference–Reduce feed rate.For Larger diameters – Increase feed rate
Single Flute - Standard Life
3/4 in x 2 in CL Single Flute Compression Router Bit - #250-2160
$559.87
$297.90
5/8 in x 2 in CL Single Flute Compression Router Bit - #250-2020
$379.99
$202.20