Standard Life 540 Series
One Flute Straight Shear O-Flute Solid Carbide Router Bits
Designed for Soft Plastics.
This bit is used where a good finish is required without chipping or tearing the plastic.
Polycarbonate, polyethylene, polypropylene, polystyrene, PVC, extruded acrylic, HDPE, UHMW and hard plastic.
Feed Rate: Soft Plastics - 350 / Hard Plastics - 300
*Based on 1/4” Diameter Tool, Cutting 1/4” Stock at 18,000 RPM
Information above should be used as a guideline – results may vary
All figures are shown as IPM (inches per minute)
Note: For smaller diameters than reference–Reduce feed rate.For Larger diameters – Increase feed rate
This bit is used where a good finish is required without chipping or tearing the plastic.
Polycarbonate, polyethylene, polypropylene, polystyrene, PVC, extruded acrylic, HDPE, UHMW and hard plastic.
Feed Rate: Soft Plastics - 350 / Hard Plastics - 300
*Based on 1/4” Diameter Tool, Cutting 1/4” Stock at 18,000 RPM
Information above should be used as a guideline – results may vary
All figures are shown as IPM (inches per minute)
Note: For smaller diameters than reference–Reduce feed rate.For Larger diameters – Increase feed rate
