Standard Life 120 Series - Two Flute Up Shear Solid Carbide Router Bits
Designed for solid woods, wood composites and some plastics.
These router bits are used where an upward chip removal is required; chip removal is optimized but adequate hold down is needed.
Feed Rate: Wood Composites - 400 / Hardwood - 350 / Softwood - 300
*Based on 1/2” Diameter Tool, Cutting 3/4” Stock at 18,000 RPM
Information above should be used as a guideline – results may vary
All figures are shown as IPM (inches per minute)
Note: For smaller diameters than reference–Reduce feed rate.For Larger diameters – Increase feed rate
These router bits are used where an upward chip removal is required; chip removal is optimized but adequate hold down is needed.
Feed Rate: Wood Composites - 400 / Hardwood - 350 / Softwood - 300
*Based on 1/2” Diameter Tool, Cutting 3/4” Stock at 18,000 RPM
Information above should be used as a guideline – results may vary
All figures are shown as IPM (inches per minute)
Note: For smaller diameters than reference–Reduce feed rate.For Larger diameters – Increase feed rate
