Standard Life 265 Series
Two Flute Compression Solid Carbide Router Bits
Designed for Double Sided Laminate or Veneered Material.
These bits are used where an excellent finish on the top and bottom, plus standard feed rates are required.
Feed Rate: Wood Composites - 650 / Hardwood - 450 / Softwood - 500
*Based on 1/2” Diameter Tool, Cutting 3/4” Stock at 18,000 RPM
Information above should be used as a guideline – results may vary
All figures are shown as IPM (inches per minute)
Note: For smaller diameters than reference–Reduce feed rate.For Larger diameters – Increase feed rate
Compression spiral, a combination of a down-cut flute and up-cut flute to maximize edge quality from the top and bottom of material.
Use on double side laminates (melamine, HPL, vinyl, painted board), solid wood and veneers.
These bits are used where an excellent finish on the top and bottom, plus standard feed rates are required.
Feed Rate: Wood Composites - 650 / Hardwood - 450 / Softwood - 500
*Based on 1/2” Diameter Tool, Cutting 3/4” Stock at 18,000 RPM
Information above should be used as a guideline – results may vary
All figures are shown as IPM (inches per minute)
Note: For smaller diameters than reference–Reduce feed rate.For Larger diameters – Increase feed rate
Compression spiral, a combination of a down-cut flute and up-cut flute to maximize edge quality from the top and bottom of material.
Use on double side laminates (melamine, HPL, vinyl, painted board), solid wood and veneers.
Two Flute - Standard Life
3/4 in x 2 in CL Two Flute Compression Router Bit - #265-2160
$534.56
$289.20
3/4 in x 3 in CL Two Flute Compression Router Bit - #265-2280
$725.82
$386.10